Application Introduction

• User can stick any side on the demonstration table and stick the other side on the display object.(Twin-End Type)
• Fix the coiled cord onto an uneasily released bar or the demonstration table then stick the adhesive pad on the object you want to protect or tie it with the ring at theend of the coiled cord and stick the alert on the table.(Ring-End Type)
• Push down the white bar to Arm it.
• The alarm will be activated immediately when any one pries up any side of them or cut the wire between them.

Key features:

• No external power or other control center required.
• Lithium battery CR1220 installed able to keep stand-by for over 3 years.
• One side with an alarm and tamper switch ; the other side with tamper switch only.
  (Twin-End type)
• Adhesive pad replaceable ; the renewal cost will be very low when you use it.
• For protecting cellular phone,PDA,camera,notebook and other expensive merchandises during demonstration.

Specifications:

• Operating voltage : 2V-3V DC
• Stand-by current consumption : 0.6uA ( Typical )
• Activation current consumption : 13mA ( Typical )
• Lithium battery CR1220 capacity : 36 mAh
• Stand-by battery life : Over 3 years
• Continuous activation battery life : Over 1 hour
• Storage battery life : Over 10 years
• Material of housing :ABS
• Material of coiled cord : PU
• Length of cord : 50 +/- 3 cm ( Relax ),120 +/- 10 cm ( Actual )
• Buzzer output : 88 +/- 3 dB ( at 1 ft.)
• Buzzer tone ( 2048 Hz ) : Continuous Bi --
• Size(mm) : LD-28,
  LD-28TW : 39(L)x15(W)x11(H),
  LD-28TS : 27(L)x18(W)x12(H).
• Packing : 20 pcs / tray ; 400 pcs / ctn,
  N.W./G.W./Mest : 6.1 Kgs/7.1 Kgs/1.1
  

Key features:

• Stick-on any smooth window or glass surface.
• With Lithium battery CR 2032 installed can keep armed for 10 years.
• To arm this alarm by pulling out the pin totally or just halfway,for ease to dearm this alarm where the window or glass is neccessary to open very often.
• Spring type sensor with no error trigger.This alarm will only be activated by the vibration caused from the window hervily punched but won't be activated due to the wind blow or violent sound pressure.
• DIY installation,Keep your home and store safe.

Specifications:

• Operating voltage : 2V - 3V DC
• Stand-by current consumption : 0.5 uA
• Activation current consumption : 30 mA
• Lithium battery CR2032 capacity : 210 mAh
• Stand-by battery life : Over 10 years
• Continuous activation battery life : Over 7 hours
• Siren output : 105 +/- 5 dB ( at 1 ft.)
• Material of housing : ABS
• Color : Ivory,or others if required.
• Packing : 1 pc/blister ; 12 pcs/inner ctn ; 144 pcs/ctn ;
  N.W./G.W./Mest : 8.5 Kgs/10.0 Kgs/2.5